My longstanding favourite toy.

Home › Forums › Which Triple do you ride? › My longstanding favourite toy.

Viewing 8 reply threads
  • Author
    Posts
    • February 4, 2020 at 10:36 pm #9934
      Anonymous

        T160 modded to just how I like it. Now if I could just get the gearbox to work properly it would be great.

        Attachments:
        You must be logged in to view attached files.
      • February 4, 2020 at 10:39 pm #9937
        Anonymous

          Not sure why pic is upside down!

          • February 5, 2020 at 11:51 am #9942
            Anonymous

              I can only think that the original picture was inverted? Anyway, I have spun it around for you.

            • February 9, 2020 at 2:26 pm #9987
              Anonymous

                🙂

            • February 5, 2020 at 6:38 am #9939
              Anonymous

                Looks well now George, what is the gearbox problem??

              • February 5, 2020 at 2:43 pm #9944
                Anonymous

                  Iain,

                  Hard to select first & second and more false neutrals than gears when changing down the box. Makes approaching corners very exciting.

                  George

                   

                   

                • February 6, 2020 at 6:50 am #9956
                  Anonymous

                    Are the Pawls and Springs in the outer case in good order George??

                  • February 7, 2020 at 5:34 pm #9977
                    Anonymous

                      Iain,

                      Nearly everything in the box has been renewed but still chasing the problem. Have now got the bike on the bench (again) and I have a lot of play in between the gear lever and the quadrant fork on right hand of bike which may be causing this issue.

                       

                      George

                       

                    • February 8, 2020 at 8:23 pm #9981
                      Anonymous

                        I think if you put a bigger washer on the nut it has the effect of clamping the crows foot

                      • February 21, 2020 at 3:32 pm #10142
                        Martin Rawson
                        Moderator

                          George the play issue is normall the fit of the crows foot to x-shaft on the LH side of engine. The other end there is normally lots of movement! Fix is either as Iian says, fit an oversize washer under nut, weld it up on shaft or ideally replace the worn item.

                        • February 21, 2020 at 6:45 pm #10146
                          Anonymous

                            All,

                            Well, I bought a new cross over shaft and quadrant from 2 different suppliers. Crossover shaft does not go through the roller bearings and has no relief for the spacer on left end  and the new quadrant has far more play than the original so a big washer it is!

                        • Author
                          Posts
                        Viewing 8 reply threads
                        • You must be logged in to reply to this topic.