

Carbys gantry balance
Home › Forums › Main Forum › Carbys gantry balance
This topic contains 3 replies, has 3 voices, and was last updated by Mark Walker 3 months, 1 week ago.
-
AuthorPosts
-
January 11, 2018 at 12:50 pm #6418
Hello, I have a question re the carbys gantry. After taking it and the carbys off about 6 times I’ve just noticed that there are internal connections between each carby mount. One of the mounts is slightly loose, so I turned it around so that the hole in it lined up with the connection. I can’t move the other 2.
? Should they all line up? Thank you. Mark.
-
January 11, 2018 at 12:56 pm #6422
Look on the Facebook site I have had the same problem
-
January 11, 2018 at 3:41 pm #6423
Hi Mark, This is a very early carb gantry with the interconnect between inlet bores, it was deleted on the later models, probably best to blank off the interconnects.
-
January 12, 2018 at 1:45 pm #6426
Thanks for that.
-
-
AuthorPosts
You must be logged in to reply to this topic.